LG WebOs 4
Last updated
Last updated
If the screen is new and has not been previously used or the Factory Reset has already been done, skip to step 2. Otherwise, perform the Factory Reset.
It is advisable to consult with Support / QA to verify that the device's default firmware is validated. We share the firmware validated on screens with incompatibilities found in their default firmware.
49/55XE4F - Remote Firmware: http://install.admira.com/firmwares/webos/4.0/XE4F/XE4F_4.26.00.epk
Go to the menu, Administrator > Factory Reset. A cancel or confirm message will be displayed. When you confirm, the screen will turn off
Turn the screen on again
Once the screen is turned on, set Language Selection and Country and Time Zone
Skip the step to configure Rotation = Off
Configure the Network Settings. In the option Internet Connection Type, select either Wired (recommended) or WIFI = OK
Skip the Timer On/Off configuration step
To install Admira, go to Menu > Quick Settings > Server Settings YES
The WebOS configuration window will then appear. Configure the following options:
Application launch Mode: Local
Fully Qualified Domain Name: On In the address bar:
http://install.admira.com/webos/2024 Application type: IPK Local Application upgrade: Remote (the screen must be connected to the Internet, otherwise an error will appear). Automatic update: Off
Once configured, reset the screen by turning it off and on again.
It is important to take into account the power settings. We must leave the configuration exactly the same as the one shown in the image
In general, it is recommended to keep screen orientation off, but we can set it to vertical at the customer’s request.
It is recommended to always use the Timer manually and not automatically.
For WebOS 4, the default security code is 0 0 0 0. You can change it to one of your choice in the menu Administrator > Change Password.
It is recommended to lock IR. Go to the menu Administrator > Access Lock > IR Lock and select: On only. In this way, the remote control will only respond to the power button.
To unlock the remote, simply keep the menu button pressed for 8 seconds and you will be prompted to enter the unlock code.
